Replacing the service door, Replacing or upgrading the hard drive – HP EliteBook Revolve 810 G2 Tablet User Manual

Page 65

Replacing the service door

Replace the service door after accessing the memory module slot, hard drive, regulatory label, and

other components.

Set the service cover down in place (1), taking care to align it properly, and then slide it toward

the battery bay until the service door snaps into place (2).

With the service bay towards you, replace the 3 captive screws at the center of the unit and the

2 screws at the edge of the unit (3). Replace the rubber covers for the 2 edge screws. Then

replace the 2 screws in the middle of the service door (4).

NOTE:

If you want to use the optional screw, it is stored inside the service door.

Insert the battery (see

Replacing or upgrading the hard drive

CAUTION:

To prevent information loss or an unresponsive system:

Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the

hard drive while the computer is on, in the Sleep state, or in Hibernation.

If you are not sure whether the computer is off, turn the computer on by pressing the power button.

Then shut down the computer through the operating system.

ENWW

Using hard drives 55