HP x2301 23-inch Diagonal Micro Thin LED Monitor - Manual (Page 14)

Connecting the Power Cord
1. Follow all electrical and power warnings.
WARNING! To reduce the risk of electric shock or damage to your equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet.
Be sure that the grounded power outlet you plug the power cord into is easily accessible to the
operator and located as close to the equipment as possible. A power cord must be routed so that
it is not likely to be walked on or pinched by items that are placed upon it or against it.
Do not place anything on power cords or cables. Arrange them so that no one might accidentally
step on or trip over them. Do not pull on a cord or cable.
For additional information, see Technical Specifications on page 21 .
2. Connect the round end of the power cord to the monitor, and then connect one end of the power
cord to the power supply and the other end to a grounded electrical outlet.
WARNING! To prevent injury from electrical shock, you must do one of the following if a
properly grounded electrical outlet is not available:
Use an electrical outlet adapter that provides proper grounding.
Have a properly grounded electrical outlet installed.
Use only the following power supply for this monitor model:
Manufacturer: Delta Electronics, Inc., model ADP-40DD B, or
Manufacturer: Lite-On Technology Corporation, model PA-1041-0
Figure 3-4 Connecting the Power Cord
8 Chapter 3 Setting Up the Monitor ENWW