HP EliteBook 755 G2 Notebook PC - Manual (Page 60)

Removing the hard drive
To remove a hard drive:
1. Save your work and shut down the computer.
2. Disconnect AC power and external devices connected to the computer.
3. Turn the computer upside down on a flat surface.
4. Remove the service door (see Removing the service door on page 48 ).
5. Remove the battery (see Removing a battery on page 39 ).
6. Loosen the 4 hard drive screws (1). Pull the hard drive tab (2) to disconnect the hard drive.
7. Lift the hard drive (3) out of the hard drive bay.
Installing a hard drive
NOTE: Your computer may look slightly different from the illustration in this section.
To install the hard drive:
1. Insert the hard drive into the hard drive bay at an angle (1).
2. Pull the plastic tab (2) toward the edge of the computer to engage the hard drive with the
connector.
50 Chapter 8 Drives