Clean the device paper path – HP LaserJet P1007 Printer User Manual

Page 59

Plug the power cord into the device.

Clean the device paper path

If you are experiencing toner specks or dots on the printouts, clean the paper path. This process uses
a transparency to remove dust and toner from the paper path. Do not use bond or rough paper.

NOTE:

For best results use a sheet of transparency. If you do not have any transparencies, you can

use copier-grade media (70 to 90 g/m

(18 to 24 lb.)) that has a smooth surface.

Make sure that the device is idle and the Ready light is on.

Load the media in the input tray.

Print a cleaning page. Access the printer Properties (or Printing Preferences in Windows 2000
and XP).

NOTE:

The cleaning process takes approximately 2 minutes. The cleaning page will stop periodically

during the cleaning process. Do not turn the device off until the cleaning process has finished. You might
need to repeat the cleaning process several times to thoroughly clean the device.

ENWW

Clean the device