HP ProBook 4446s Notebook-PC - Manual (Page 64)

6. Remove the service door (see Removing or replacing the service door on page 52 ).
NOTE: Instructions for removing the hard drive are imprinted on the service door.
7. Remove the four hard drive screws (1) from the hard drive.
8. Pull the tab on the hard drive (2) towards the side of the computer to disengage the hard drive
from the connector, and then lift the hard drive out of the hard drive bay.
NOTE: The hard drive may be wrapped in a plastic covering. After removing the hard drive
from the computer, you must remove the plastic covering to access the hard drive itself.
Installing a hard drive
To install the hard drive:
1. Insert the hard drive into the hard drive bay.
2. Pull the plastic tab on the hard drive (1) towards the center of the computer to engage the hard
drive with the connector.
54 Chapter 8 Drives