HP ProLiant BL45p Server series User Manual
Hp proliant bl45p server blade user guide
Table of contents
Document Outline
- HP ProLiant BL45p Server Blade User Guide
- Notice
- Contents
- Component identification
- Operations
- Setup
- Hardware options installation
- Local I/O cabling
- Configuration and utilities
- Troubleshooting
- Troubleshooting resources
- Server diagnostic steps
- Preparing the server for diagnosis
- Symptom information
- Service notifications
- Loose connections
- Diagnostic steps
- POST error messages and beep codes
- Introduction to POST error messages
- Invalid memory types were found on the same node. Please check DIMM compatibility. - Some DIMMs may not be used
- Fibre Channel Mezzanine/Balcony Not Supported.
- Memory found on unpopulated Node. — Processor is required to be installed for memory to be used.
- Mixed processor speeds detected. Please make sure that all processors are the same speed. — System Halted!
- Node Interleaving disabled - Invalid memory configuration
- There must be a first DIMM in pair if second DIMM in pair is populated. Second DIMM in pair ignored.
- Unsupported DIMM(s) found in system. - DIMM(s) may not be used
- 1610-Temperature Violation Detected. - Waiting 5 Minutes for System to Cool
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Declaration of conformity for products marked with the FCC logo, United States only
- Cables
- Modifications
- European Union regulatory notice
- Canadian notice (Avis Canadien)
- Japanese notice
- BSMI notice
- Korean notice A&B
- Battery replacement notice
- Taiwan battery recycling notice
- Electrostatic discharge
- Specifications
- Technical support
- Acronyms and abbreviations
- Index