HP Deskjet D5560 Printer - Manual (Page 8)

Use PIN method
a. Load paper.
❑ Insert stack of paper into input tray with short edge forward and print side
down.
❑ Slide stack of paper forward until it stops.
❑ Slide paper-width guide to the right until it stops at edge of paper.
b. Initiate WiFi Protected Setup.
❑ Press and hold the Resume button for two seconds.
❑ Wireless test starts.
❑ Wireless test report and Network Configuration report are printed
automatically.
c. Set up wireless connection.
❑ Press and hold the Wireless button for two seconds.
❑ Enter the PIN on a computer for the router.
❑ The Wireless icon and signal strength bar appear solid on successful
configuration of the wireless network.
d. Install software
NOTE: The product begins a timer for approximately two minutes in which the
corresponding button on the networking device needs to be pressed.
2. View the animation for this topic.
Related topics
Install the software for a network connection
Test wireless setup and print network configuration page
The wireless network test performs a series of diagnostic tests to determine whether
network setup is successful. You can print the wireless network test at any time.
You can print a network configuration page to see network settings such as the IP
address, communication mode, and network name (SSID).
To print the network configuration page
▲ Press and hold the Resume button to initiate the wireless test and print the Network
Configuration and Network Test pages.
Chapter 2
6 Finish setting up the HP Printer
Fi
nis
h
s
e
tti
ng
u
p
t
h
e
H
P
P
rin
te
r