HP StorageWorks 2.64 Director Switch - Manual (Page 67)

Configuring the Product
67 Embedded Web Server User Guide
Note: Fabric Binding is also enabled automatically, when the Enterprise Fabric Mode
is enabled. However, in this case, only attached fabric members are included in the
active FBML. For more information, see “ Fabric Binding and the Enterprise Fabric
Mode ” on page 72.
1. Select Configure from the navigation panel.
2. Select the Security tab and the Fabric Binding tab. The Fabric Binding tab
view displays ( Figure 17 ).
3. To activate Fabric Binding, select the Save and Activate button. All
members of the pending FBML are activated on the switch.
Deactivating Fabric Binding
Note: You cannot deactivate Fabric Binding if Enterprise Fabric Mode is enabled.
To deactivate Fabric Binding, perform the following procedure:
1. Select Configure from the navigation panel.
2. Select the Security tab and the Fabric Binding tab. The Fabric Binding tab
view displays ( Figure 17 ).
3. Select the Deactivate button. The Fabric Binding status changes from active
to inactive.
Configuring the Pending FBML
You can use any of multiple methods to populate and configure the pending
FBML. Consider the following methods:
■ To see whether the pending FBML is identical to the active FBML list, see
“
Determining If the Pending FBML and Active FBML Are Identical ” on
page 68.
■ To manually add list members, see “ Adding to the Pending FBML ” on
page 68.
■ To manually delete list members, see “ Deleting a Member from the Pending
FBML ” on page 69.