HP 2000fc Modular Smart Array - Manual (Page 58)

58 HP 2012fc Modular Smart Array user guide • January 2013
Mapping a Data Host to a Volume
To enable a data host to access a volume you created, you must map the volume to
the host. The port World Wide Name (WWN) of each host connected to the system
is automatically added to the system’s global host port list.
Before mapping a data host to a volume you must identify the data host’s port
WWN and a LUN that the host is not using.
To map a data host to a volume:
1. Select Manage > Volume Management > Volume Mapping > Map Hosts To
Volume.
Notice that your first virtual disk and its volume are selected, and the volume’s host
mapping values are set to None.
2. In the Assign Host Access Privileges panel:
a. Select the host port WWN value that you identified before beginning.
b. Type the LUN that you identified.
Notice that the mapped host will have read-write access through all controller
host ports.
c. Click Map It.