Duplicating a zone set, Deleting a zone, 108 replace zone member dialog box – HP StorageWorks 2.32 Edge Switch User Manual
Page 205: Figure 108
Configuring Zoning
205
Figure 108: Replace Zone Member dialog box
5. Enter the domain ID and port or the WWN of the replacement member.
6. Click OK.
Duplicating a Zone Set
1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
2. Choose a fabric from the Fabric drop-down list. This sets the fabric to target
all zoning actions.
3. Click the Zone Library tab.
4. Right-click a zone set in the Zone Sets list and choose Duplicate to duplicate
the zone set or Deep Duplicate to duplicate the zone set and all its zones. The
copied zone set displays.
5. Enter a new name for the zone set, if desired. See “
6. Click OK.
Deleting a Zone
1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
2. Choose a fabric from the Fabric drop-down list. This sets the fabric to target
all zoning actions.
3. Click the Zone Library tab.
4. Right-click a zone in the Zones list and choose Delete.