HP StorageWorks 2.32 Edge Switch - Manual (Page 192)

Configuring Zoning
192 HA-Fabric Manager User Guide
Configuring Zoning
Note: Only one appliance should be run at a time (actual appliances performing
discovery) or log on conflicts may occur.
To configure zoning for the SAN, perform the following:
1. Choose Configure > Zoning. The Zoning dialog box displays, as shown in
Figure 101 .
Figure 101: Zoning dialog box
Note: The information displayed in the Zoning dialog box may not be current after 30
minutes. Re-open the dialog box to increase zoning discovery speed and get the
current information.