Fio-beacon, Fio-bugreport – HP MSR Encryption Accelerators User Manual
Page 41

Utilities 41
You can specify multiple IO Accelerator devices. For example, /dev/fct1 /dev/fct2 indicates the
second and third IO Accelerator devices installed on the system. You can also use a wildcard to indicate all
IO Accelerator devices on the system.
For example, /dev/fct*
Option
Description
-c
Attach only if clean.
-q
Quiet: disables the display of the progress bar and
percentage.
fio-beacon
Description
The fio-beacon utility enables all three LEDs on, to identify the specified IO Accelerator device.
IMPORTANT:
This utility enables the LEDs on, unless you select the -0 option.
Syntax
fio-beacon
where
2, and so on. For example, /dev/fct0 indicates the first IO Accelerator device installed on the system.
Options
Description
-0
Off: Turns off the three LEDs
-l
On (default): Enables the three LEDs on
-p
Prints the PCI bus ID of the device at
may be written to standard output rather than to standard error.
fio-bugreport
Description
Prepares a detailed report of the device for use in troubleshooting problems. The results are saved in the
/tmp directory in a file that indicates the date and time the utility was run.
Example
/tmp/fio-bugreport-20100121.173256-sdv9ko.tar.bz2
Syntax
fio-bugreport
NOTE:
If the utility recommends that you contact Fusion-io support, disregard that message and
contact HP support
Sample output
-bash-3.2# fio-bugreport /tmp/fio-bugreport-20090921.173256-sdv9ko ~
Collecting fio-status -a
- AXL300 Accelerator SSL PCI Card Thunderbolt-2 PCIe 1-port IO Card Storage C-series Switch Accelerators Fusion ioFX 410GB PCIe Accelerator Thunderbolt 2-Port AiO Module B-series Switch Accelerators IO Accelerator for BladeSystem c-Class HPAtalla AXL600L SSL Accelerator Card PCIe IO Accelerators for ProLiant Servers