HP MSR Encryption Accelerators - Manual (Page 40)

Utilities 40
Utilities
Utilities reference
The IO Accelerator installation packages include various command line utilities, installed by default to the
/usr/bin file. These utilities provide a number of useful manners to access, test, and manipulate your
device.
Utility Purpose
fio-attach Makes an IO Accelerator available to the OS
fio-beacon Lights the IO Accelerator external LEDs
fio-bugreport Prepares a detailed report for use in troubleshooting issues
fio-detach Temporarily removes an IO Accelerator from OS access
fio-format Used to perform a low-level format of an IO Accelerator
fio-pci-check Searches for errors on the PCIe bus tree, specifically for
PCIe IO Accelerators
fio-snmp-agentx SNMP subagent that implements the SNMP
FUSION-IODRV-MIB for the IO Accelerator
fio-status Displays information about the device
fio-sure-erase Clears or purges data from the device
fio-update-iodrive Updates the IO Accelerator firmware
NOTE: All utilities have –h (Help) and –v (Version) options.
fio-attach
Description
Attaches the IO Accelerator device and makes it available to the operating system. This creates a block
device in /dev named fiox (where x is a, b, c, and so on). Then, you might partition or format the IO
Accelerator device, or set it up as part of a RAID array. The command displays a progress bar and
percentage as it operates.
NOTE: In most cases, the IO Accelerator automatically attaches the device on load and does a
scan. You only have to run fio-attach if you ran fio-detach or if you set the IO Accelerator
auto_attach parameter to 0.
Syntax
fio-attach [options]
where is the name of the device node (/dev/fctx), where x indicates the card number: 0, 1,
2, and so on. For example, /dev/fct0 indicates the first IO Accelerator device installed on the system.