HP NonStop G-Series User Manual
Page 145
Command Interpreter
HP AutoSYNC User’s Guide—522580-019
8-51
ALTER SYNCFILESET
The default is 1000.
NETWORKSECURE | NO NETWORKSECURE
enables or disables changing the security of the destination files for network
access.
By default this option is enabled and file security is changed as follows:
The default is NETWORKSECURE, but the SECURE option overrides
NETWORKSECURE.
NOSAFEGUARD | NO NOSAFEGUARD
specifies that the Safeguard ACL for a source Enscribe disk file is not
propagated to the destination when the file is synchronized. A warning is
written to the logfile to notify the user that the Safeguard setting for the source
file has been turned off on the destination.
The default is NO NOSAFEGUARD and the ACL for a source file is
propagated to the synchronized destination file.
RECOVERY | NO RECOVERY
enables or disables the recovery option.
If recovery is enabled, AutoSYNC saves a copy of an existing destination file to
an archive subvolume before it restores a later copy of the file. If a failure
occurs during the synchronization and the file is corrupted, the archived copy is
recovered and replaces the corrupted file.
This option overrides the global parameter [AUTO]SYNCRECOVER.
By default, recovery is enabled.
RENAMEO[PEN] | NO RENAMEO[PEN]
specifies (or disables the option) that destination unaudited files that are
opened for shared READ access or running object files are to be renamed to
allow AutoSYNC to replace them.
The syncuser must have PURGE privileges to the destination file for the
RENAME to succeed.
Source file security
Destination file security
“A”
“N”
“G”
“C”
“O”
“U”
“-”
“-”