HP Storage Mirroring V5.1 Software - Manual (Page 26)

9 - 2

Delete Snapshot—If you no longer want to keep a snapshot, you can delete it by highlighting
the snapshot in the Existing Snapshots list and clicking Delete Snapshot. To help you
understand the snapshots, use the Type and Status columns. The Status indicates the state of
the connection between the source and target at the time the snapshot was taken. the Type
information is displayed in the following table.
Type Description
Scheduled This snapshot was taken as part of a periodic snapshot.
Deferred This snapshot was taken as part of a periodic snapshot, although it did not
occur at the specified interval because the connection between the source
and target was not in a good state.
User Request This snapshot was taken manually by a user.
NOTE: The Schedule options at the top of the Snapshot Manager are the same options from the
Configure Protection Protection tab. If you change the options in one location, they will
be changed in the other location too.
The Existing Snapshots list only contains snapshots from Full-Server Failover.
Snapshots from other utilities and tools will not be listed.