Asus 54Mbps Pocket Wireless Access Point WL-330g - Manual (Page 66)

A-2 Appendix
Problem Action
The ASUS Pocket Wireless AP
does not power up. • Use a test meter to measure the
voltage output of the power
source through the power plug.
• Check if the power plug is
properly connected to the device.
Other devices cannot
communicate with the ASUS
Pocket Wireless AP through a
wired network connection. • Verify your network configuration
to ensure that there is no IP
address duplication. Turn off the
device in question, then ping the
assigned IP address of the
device. Make sure no other
device responds to that address.
• Check if the cables have the
proper pin outs and connectors.
You may also use another LAN
cable.
• Make sure the hub, switch, or
computer connected to the
ASUS Pocket Wireless AP
supports 10Mbps or 100Mbps
speed.
Do this by check the ASUS
Pocket Wireless AP and the
Hub LEDs. When you connect
the ASUS Pocket Wireless AP
to a 10/100 Mbps hub, both the
Hub LED and the ASUS Pocket
Wireless AP Ethernet LEDs
should light up.
This troubleshooting guide provides solutions to some common
problems that you may encounter while installing and/or using ASUS
Pocket Wireless AP. These problems require simple troubleshooting
that you can perform by yourself. Contact the ASUS Technical Support
if you encounter problems not mentioned in this section.