Asus 54Mbps Pocket Wireless Access Point WL-330g - Manual (Page 20)

2-2 Chapter 2: Installation
2.1 System requirements
Before installing the ASUS Pocket Wireless AP, make sure that your
system/network meets the following requirements:
• An Ethernet RJ-45 port (10Base-T/100Base-TX)
• At least one IEEE 802.11b/g device with wireless capability
• An installed TCP/IP and Internet browser
2.2 Device installation
Follow these instructions to install the ASUS Pocket Wireless AP.
1. Install the device utilities from the support CD.
2. Connect the device to your computer, network hub, switch, or router.
2.2.1 Before you proceed
Take note of the following guidelines before installing the ASUS Pocket
Wireless AP.
• The length of the Ethernet cable that connects the device to the
network (hub, ADSL/cable modem, router, wall patch) must not exceed
100 meters.
• Place the device on a flat, stable surface as far from the ground as
possible
• Keep the device clear from metal obstructions and away from direct
sunlight.
• Keep the device away from transformers, heavy-duty motors,
fluorescent lights, microwave ovens, refrigerators, and other industrial
equipment to prevent signal loss.
• Install the device in a central area to provide ideal coverage for all
wireless mobile devices.
• Install the device at least 20cms from a person to insure that the
product is operated in accordance with the RF Guidelines for Human
Exposure adopted by the Federal Communications Commission.