Agri-Fab 45-02931 - Manual (Page 5)

5
FIGURE 7
10. Assemble the boom mount bracket to the rear of
the frame tubes using two 5/16" x 2" hex bolts and
5/16" hex nuts.
See figure 5.
FIGURE 5 REAR VIEW
11. Assemble the boom bars to the boom mount
bracket using two 5/16" x 1-1/4" carriage bolts,
tooth lock washers (between the bar and bracket),
5/16" flat washers and knobs. The boom connect-
ing hose should extend upward. See figure 6.
NOTE: Make sure the nozzles are adjusted so that
the openings face straight down when the boom
bar is in the horizontal operating position.
FIGURE 6
5/16" HEX NUT
5/16" x 2"
HEX BOLT
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" FLAT
WASHER
WASHER
(TOOTH LOCK)
BOOM BAR
BOOM CONNECTING HOSE
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL) #10 x 1/2"
SCREW
#10 LOCK
WASHER
12. Assemble the large and small spray gun clips to the
side of the tank using two #10 x 1/2" screws and #10
lock washers. See figure 7.