Electrical connection – AEG Lavamat 74900 User Manual

Page 46

If you intend the drain hose from the
machine to empty into a sink, make sure
that the sink is empty and the plug hole is
not blocked. Use the plastic “U -Piece” sup-
plied.
Important

Before connecting up the machine to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris that may have collected in the
pipes.

In the interest of the environment

Washing machines and dish-
washers should be connected
to the FOUL drainage system,
the water will then be taken
to a sewage works for treat-
ment before being discharged
safely into a river.
It is essential that these appli-
ances are not connected to the
surface water drainage system
as this water is discharged
directly into a river or stream
and may cause pollution.
If you require any further
advice please contact your local
water authority.

Electrical connection

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure
not be observed.
If the plug that is fitted to your appliance is not suitable for your sock-
et outlet, it must be cut off and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent the hazard of
shocks in case it should be plugged into a 13 Amp socket in another
part of your home.

Installation

SHOWER

BATH

SINK TOILET

BIDET

WASHING

MACHINE DISHWASHER

RAINWATER

'RUN-OFF'

SURFACE WATER

DRAINS & SEWERS

UNTREATED

DISCHARGE

RIVER

FOUL DRAIN

FOUL SEWERS

SEWAGE

TREATMENT

WORKS