Avaya VF 3000 - Manual (Page 60)

TC; Reviewed:
PV 04/24/2006 Avaya – Proprietary
Use as authorized only pursuant to your signed agreement or
Avaya policy. No other disclosure is permitted or authorized.
60 of 61
HT3-LSP-VF.doc
• Verify the Avaya Communication Manager is updating the LSP by running command
“save trans lsp” from the SAT interface. Use command “disp lsp” to verify the
translation updated the time and date.
8. Conclusion
These Application Notes describe the procedures for provision the Local Survivable Processor
(LSP) in an Avaya Hosted IP Telephony R3.0 environment. The steps provided should be helpful
for implementing most deployments, but do not address all possible configuration scenarios.
9. References
[1] Configuring the Juniper NetScreen-25 Firewall, User Manual, Release 5.1.0.
Available from Juniper Networks at http://www.juniper.net/
[2] VF Series, JUNIPER VF 3000 SBC, Installation and User Manual, Release 6.0.3.
Available from Juniper Networks at http://www.juniper.net/
[3] Administration Guide for Avaya Communication Manager, Doc ID 03-30050.
10. Glossary
Technical
Term Definition as it pertains to this document
HIPT
Hosted IP Telephony
HCC Hosted Contact Center
LSP Local Survivable Processor
CM Communication Manager
PE Processor Ethernet
SBC Session Boarder Controller
MIP Mapped IP
SRP Session Routing Policy
FW Firewall
NAT Network Address Translation