Avaya VF 3000 - Manual (Page 15)

6. Avaya Hosted IP Telephony Release 3.0 LSP Configuration
6.1. PC-LAN Configuration (Private-Private)
6.1.1. Configure Avaya Communication Manager
The following Avaya Communication Manager provisioning is required to support the LSP
Configuration. This provisioning is performed via the SAT interface. In the following example,
the Avaya Communication Manager for LSP support is provisioned for site A1. Refer to [3] for
additional configuration information for Avaya Communication manager.
6.1.1.1. License Avaya Communication Manager
Avaya Communication Manager must be licensed to enable the special application “SA8853
Support of LSPs behind NAT”.
Step 1. Use the “change system-parameters special-applications” command to enable the
special application “SA8853 Support of LSPs behind NAT”. Select Esc-n to page for SA8853,
select y and submit the changes as shown in Figure 6.
Figure 6
Note: If this feature is installed as a patch (red feature) the feature will not show up on the Avaya
Communication Manager SA form as shown above. In a subsequent GA release, the feature
(green feature) will be part of the SA form, which can be enabled based on licensing.
TC; Reviewed:
PV 04/24/2006 Avaya – Proprietary
Use as authorized only pursuant to your signed agreement or
Avaya policy. No other disclosure is permitted or authorized.
15 of 61
HT3-LSP-VF.doc