Alcatel-Lucent OMNIACCESS 740 - Manual (Page 50)

Starting the OmniAccess 740
Left running head:
Chapter name (automatic)
42
Beta Beta
OmniAccess 740 Hardware User’s Guide
Alcatel-Lucent
C
HECKING
C
ONDITIONS
P
RIOR TO
S
YSTEM
S
TARTUP
Before you power ON the OA-740, check the following:
1. Ensure that the utility power cable is connected to a valid power cord in the rear
panel, and power is available from this source.
2. Ensure that the SE is correctly and securely installed.
3. Ensure that a PC or VT100 terminal is connected to the console port, using the
appropriate console cable. (If the system is not connected to a console, see the
“Connecting to the System Console Port” section of this document to connect
the system to a console.)
S TARTING THE OA-740
After installing the OA-740 and connecting the cables, follow the procedure given
below to start the system:
Step 1: Power ON the OA-740.
Power on the OA-740 by turning on the external power switch located near the
power cord on the rear panel. If power supply is available, you can hear the
rotation of system fans, and the system begins the bootup sequence.
Step 2: Monitor the system for various bootup messages.
Once the system begins to startup, monitor the SE LEDs for various stages of the
booting process.
The following table shows the state of SE LEDs after startup.
Table 19: LED Status
LED Status Description
SE LEDs
Active Off Power up status. This is the default
display when the system is first
powered on and before the software is
loaded.
Green SE card is active.