Preventing electrostatic discharge damage, Beta – Alcatel-Lucent OMNIACCESS 740 User Manual
Page 38
Installing the OmniAccess 740
Left running head:
Chapter name (automatic)
30
Beta
Beta
OmniAccess 740 Hardware User’s Guide
Alcatel-Lucent
Warning: Explosive Device Proximity Warning—Do not operate the OA-740 near unshielded
blasting caps or in an explosive environment unless the unit has been modified
especially to be qualified for such use.
In addition, use these appropriate guidelines while working with any equipment
that is disconnected from a power source, but still connected to the telephone
wiring or other network cabling:
•
Never install or remove telephone wiring during a lightning storm.
•
Never install or remove telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
•
Never touch un-insulated telephone wires or terminals unless the telephone line
has been disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
P
REVENTING
E
LECTROSTATIC
D
ISCHARGE
D
AMAGE
Electrostatic Discharge (ESD) damage, which occurs when electronic cards or
components are improperly handled can result in complete or intermittent system
failures. The line cards consist of printed circuit boards with Integrated Circuits
(IC) and should be handled at edges or faceplate only.
Warning: Always tighten the captive tabs and levers on all the devices. These tabs and levers
prevent accidental removal, provide proper grounding for the system, and help to
ensure that the cards are properly fitted in the shelf.
Follow the guidelines given below for preventing ESD damage:
•
Always use an ESD wrist strap or ankle strap and ensure that it makes good skin
contact and is properly grounded.
•
Do not touch the printed circuit board, and avoid contact between the printed
circuit board and your clothing.
•
Ensure the line cards are fully inserted in their respective chassis slots and the
thumb screws are tightened.
Warning: For safety, periodically check the resistance value of the antistatic strap. The
measurement should be in 1 and 10 mega ohms range.