LG PF85U - Manual (Page 4)

4 SAFETY INSTRUCTIONS
y Do not place the product close to
sources of steam, oil or oil mist, such
as humidifiers and kitchen counters.
- Failure to do so may result in fire,
electric shock, or corrosion.
y Do not install the product onto a wall
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
y Do not place the projector where it
might be exposed to dust.
- This may result in fire.
y Do not use the projector in a damp
place such as a bathroom where it is
likely to get wet.
- This may result in fire or electric
shock.
y Do not allow a tablecloth or curtain to
block the air vent.
- This may result in fire due to the
increase in the internal temperature.
y Ensure good ventilation around the
projector. The distance between the
projector and the wall should be at
least 30 cm (11.8 inches).
- This will prevent fire due to the
increase in the internal temperature.
CAUTION
y When placing the projector on a table
or shelf, be careful not to put it near
the edge.
- The projector could fall due to bal- The projector could fall due to bal- The projector could fall due to bal-
ance problems, which may cause per-
sonal injury or damage to the prod-
uct. Make sure to use the projector
cabinet or stand that fits the projector.
y When moving the projector, make
sure to switch it off and remove the
power plug and cords.
- The power cord may be damaged,
resulting in fire or electric shock.
y Do not place the projector on an
unstable or vibrating surface such as
a wobbly shelf or a slope.
- It may fall and cause injury.
y Be careful not to tip the projector over
when connecting external devices to
the projector.
- This may cause personal injury or
damage to the projector.
Power
WARNING
y The grounding wire should be con-
nected.
- Ensure that you connect the ground-
ing cable to avoid electric shock.
If it is not possible to ground the unit,
have a qualified electrician install a
separate circuit breaker.
Do not try to ground the projector
by connecting it to telephone wires,
lightning rods or gas pipes.
y The power plug should be inserted
fully into the power outlet.
- An unstable connection may cause
a fire.
y Do not place heavy objects on the
power cord.
- This may result in fire or electric
shock.
y Never touch the power plug with wet
hands.
- This may result in electric shock.
y Do not plug too many devices into
one multi-power outlet.
- This may result in fire due to the
power outlet overheating.
y Prevent dust from collecting on the
power plug pins or outlet.
- This may result in fire.
y To turn off the main power, remove
the power plug, which should be
positioned so it is easy to access for
operation.