LG BG630 - Manual (Page 15)

15 PREPARATION
Installation
Installation Precautions
y Make sure to remove the protective
film attached to the projector.
- If you use the projector without
removing the protective film, the
product may not work properly.
y Place the projector in a well-ventilated
environment.
- To prevent internal heat from
building up, install the projector in
a well-ventilated place.
Do not place anything near the
projector as this may block its air
vents. If the air vents are blocked,
the internal temperature will in-
crease.
- Do not place the projector on a
carpet or rug. If a product has its
inlet vent on its bottom, do not
block the vent and use the product
on a leveled solid surface.
- Be sure to prevent foreign objects,
such as scraps of paper, from
entering the inlet vent.
- Leave an adequate distance (30 cm
or more) around the projector.
y Do not place the product in a hot or
humid environment.
- Do not place the product in a hot,
cold, or humid environment.
y Do not place the product in a dusty
place.
- This may cause fire.
y Never open any cover on the projec-
tor. There is a high risk of electric
shock.
y The projector is manufactured using
high-precision technology. You may,
however, see tiny black dots and/
or bright colored dots (red, blue or
green) that continuously appear on
the projector screen. This is a normal
result of the manufacturing process
and does not indicate a malfunction.
y The remote control may not work
in an environment where a lamp
equipped with electronic ballasts or
a three-wavelength fluorescent lamp
is installed. Replace the lamp with an
international standard lamp for the
remote control to work normally.