Asus CUBX - Manual (Page 39)

ASUS CUBX User’s Manual 39
3. HARDWARE SETUP
Connectors
3. H/W SETUP
23) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least 10mA
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
CUBX
®
CUBX ATX Power Connector
ATXPWR
+3.3 V
o
lts
-12.0 V
olts
Ground Power Supply On Ground Ground Ground -5.0 V
o
lts
+5.0 V
o
lts
+5.0 V
o
lts
Power Good
+12.0 V
olts
+3.3 V
olts
+3.3 V
olts
Ground
+5.0 V
olts
Ground
+5.0 V
olts
Ground
+5V Standby
24) Power Supply Thermal Sensor Connector (2-pin block JTPWR)
If you have a power supply with thermal monitoring, connect its thermal sensor
cable to this connector.
CUBX
®
CUBX Thermal Sensor Connector
JTPWR
Power Supply Thermal Sensor Connector