Asus WL-530g - Manual (Page 37)

3. Utilities
ASUS Pocket Wireless Router 37
Chapter 3 - Software Configuration
IP Config (Cont.)
Get DNS Server automatically? - Normally this is automatic and you
would answer “No” to the question about manually assigning DNS. If you
are given instructions from your ISP to enter DNS addresses, select “Yes”
to manually assigning DNS.
DNS Server 1/DNS Server 2 - If you are given instructions from your ISP
to enter DNS addresses, select “Yes” to manually assigning DNS and enter
the IP addresses here.
PPPoE or PPTP Account
These three items are editable only when WAN Connection Type is set as
PPPoE or PPTP.
User Name - The name of your Internet account provided by your ISP.
Some ISPs work with the entire account name along with the hosting domain
(such as [email protected]) and others require that you enter
only the account name (yourname).
Password - Enter the password for your Internet account.
Idle Disconnect Time in seconds (option) - Enter the number of seconds
of inactivity to disconnect you from your ISP.
PPPoE MTU - This field is shows the Maximum Transmission Unit (MTU)
of PPPoE packets.
PPPoE MRU - This field is shows the Maximum Receive Unit (MTU) of
PPPoE packets.
Enable PPPoE Relay - Enable PPPoE relay allows stations in LAN to
setup individual PPPoE connections that are passthrough NAT. It is also
known as PPPoE multi-session.
Special Requirement from ISP
The following items may be specified by some ISPs. Check with your ISP
and fill them in if required.
Host Name – Fill this in if required by your ISP.
MAC Address – Fill this in if required by you ISP.
Heart-Beat Server – Fill the server name or server IP address when you
are connecting with BigPond.
LAN IP Setting
IP Address - This is IP address of the Wireless Router as seen in your local
network. The default value is 192.168.1.1.
Subnet Mask - This is Subnet Mask of the Wireless Router as seen in your
local network. The default value is 255.255.255.0.