APC Smart-UPS URTA48XLBPJ - Manual (Page 7)

Battery Pack and UPS Connection Procedure
Smart-UPS RT SURTA48XLBP/SURTA48XLBPJ External Battery Pack User Manual 7
b. Install the UPS and battery pack battery covers  and bezels .
6. Go to “Terminal Mode Configuration” on page 9 to configure the UPS to recognize the battery
pack(s).
Battery Pack and UPS Connection Procedure
The battery pack is equipped with the following connectors. Refer to the UPS user manual for UPS
connector types and definitions.
Connectors Type Description
TVSS screw The UPS and battery pack features a Transient Voltage Surge-suppres-
sion (TVSS) screw located on the rear panel, for connecting the ground
cable on surge suppression devices such as telephone and network line
protectors.
N
OTE : Prior to connecting the grounding cable, turn off the UPS and
disconnect it from the utility power outlet.
battery pack
connector
Smart-UPS RT battery packs provide extended run-time during power
outages. A maximum of 10 battery packs can be used with the UPS.
N
OTE : See the APC Web site, www.apc.com for information on the
battery pack, SURTA48XLBP or SURTA48XLBPJ.
Caution
Prior to connecting the grounding cable, ensure that the UPS is NOT connected to
utility or battery power circuits. See the UPS user manual for additional
instructions.
 