Canon Speedlite Transmitter ST-E2 - Manual (Page 3)

Contents
1. Nomenclature 22
2. Readying t h e ST-E2 23
3. Readying the (Slave Setting) 25
4. Basic Wireless E-TTL Autoflash Operation 26
5. Wireless Multi-Flash E-TTL Autoflash Operation 29
6. Applications 33
7. Troubleshooting 34
Specifications .35
Note
All t h e operation instructions in this booklet assume t h a t the ST-E2 and other relevant equipment a r e
already turned on. Before proceeding, make sure the ST-E2 and other equipment on.
I I
This complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not
cause harmful interference, and this device must accept any interference including that may cause
undesired operation.
Do not make any changes or modifications the equipment unless otherwise specified in the instructions. If such or
modifications should be made, you could be required to stop operation of the equipment.
This equipment has been tested and found to with the for a class B digital device, pursuant to part FCC
Rules. These limits arc designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, which be determined by turning the equipment off and on, the user is
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Consult the dealer or a n experienced technician for help.
COPY