Canon imagePROGRAF iPF9400 - Manual (Page 7)

7
MEMO
Remove the Packaging Material
1 2
3
a
4 5 6
a
b
9 8 7
b
a
Open the Top Cover . Remove the tape and other packaging
material used to secure the printer.
Use the Allen Wrench to loosen the Belt Stopper screw (a) and remove the screw from the Belt
Stopper. Unscrew the Belt Stopper to the left and remove the stopper.
Pull the carriage spacer (b) in the direction of the arrow to remove it.
Lift the Ejection Guide. Attach the six Ejection Support s (a) on
the back of the Ejection Guide .
• The Belt Stopper, screw, carriage spacer,
and Allen Wrench are needed when
moving the printer to another location later.
Keep the Belt Stopper, screw, carriage
spacer, and Allen Wrench which have
been removed. Neglecting to attach the
Belt Stopper and carriage spacer may
cause damage to the printer when moving
the printer to another location.
• After opening the Top Cover, Cleaning
Brush is stored on the right. Take out the
brush when cleaning inside the Top Cover.
Close the Ejection Guide and Top
Cover .
Plug the power cord into the Power
Supply Connector on the back of the
printer.
Plug the power cord into the outlet. When lowering the Ejection Guide (a),
lower it slowly. If you lower it vigorously,
the Ejection Supports (b) may touch the
roll paper and scratch the printing surface.