Ariens 939 SNO-THRO 939001 - Manual (Page 20)

6 - 20
6.1 INSPECT LOWER HANDLEBAR
1. Remove bolts attaching lower handlebar to each
side of frame (2 places, each side) (see Figure 20).
2. Remove handlebar assembly.
3. Check lower handlebar parts for wear or
replacement
4. Assemble, using reverse procedure.
6.2 REPLACE LOWER HANDLEBAR
Figure 20
1. Remove locking nuts, lock washers, washers, and
spacers from bolt attaching upper handlebars to
lower handlebars (2 places, each side).
2. Lay upper handlebars and control panel on bench
or ground.
NOTE: Removing control cables is not necessary to
replace lower handlebars.
3. Remove bolts attaching lower handlebar to each
side of frame (2 places, each side).
4. Remove lower handlebar.
5. Install new lower handlebar using reverse
procedure.
6. Attach upper handlebars to lower handlebars.
6.3 TRACTION DRIVE CLUTCH LEVER
AND CABLE
Clutch Lever
Figure 21
1. Remove jam nut and flat washer from bolt.
2. Remove bushings and torsion spring.
3. Remove retaining ring and traction cable
4. Remove clutch lever.
5. Check parts for wear or replacement.
6. Assemble, using reverse procedure. Attach cable
to bolt during assembly.
7. Adjust clutch lever position if necessary (see
“Traction Drive Clutch Adjustment” on page 19).
Traction Drive
Figure 21
1. Remove clutch lever from upper handlebar (See
preceding Clutch Lever for procedure.)
2. Slide cable off bolt.
3. Disconnect cable spring from control under frame.
4. Check cable for wear. Replace if necessary
5. Assemble, using reverse procedure.
NOTE: BE sure to route cable over small pulley
mounted to frame
6. Adjust clutch lever position if necessary (see
“Traction Drive Clutch Adjustment” on page 19).
SECTION 6 - HANDLEBARS & CONTROLS
Figure 20
4
5
3
1
2
1. Upper Handlebars
2. Bolt w/Nut, Spacer
and Washers
3. Lower Handlebars
4. Bolts
5. Frame
PS0350-1