Brother DZ2750 - Manual (Page 79)

77
3
————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
f
After checking the entered characters, start
sewing.
• For details on sewing characters, refer to
“Sewing the character stitches” (page 78).
Memo
● The combination of characters will be
stored in memory even if you turn off the
machine.
■ Adding new characters after sewing
After sewing a combination of characters, you
can add characters to the combination using the
following method.
Memo
● When you have finished sewing, the pattern
No. of the first character in the current
combination is shown on the LCD.
a
Press the stitch category selection key to
select the character stitch again. (Do not skip
this step.)
a Stitch category selection key
b
Add new characters by following the
procedure described in “Combining
characters” (page 76).
X
New characters are added next to the
last character of the combination.
■ Making a new combination of characters after
sewing
Memo
● When you have finished sewing, the pattern
No. of the first character in the current
combination is shown on the LCD.
a
Select the first character of the new
combination.
b
Press the “+” side of (stitch width
adjustment key).
a Stitch width adjustment key
X The old combination of characters is
cleared from memory, and the pattern
No. shown in the LCD is entered as the
first character of a new combination.
c
Add characters by following the procedure
described in “Combining characters”
(page 76).