Brother DCP-8085DN - Manual (Page 84)

Troubleshooting and routine maintenance
71
C
Print quality difficulties
C
Difficulties Suggestions
Printed pages are curled. „ Low quality thin or thick paper or not printing on the
recommended side of the paper could cause this problem. Try
turning over the stack of paper in the paper tray.
„ Make sure that you choose the Paper Type that suits the print
media type you are using. (See Acceptable paper and other
print media on page 14.)
Printed pages are smeared. The Paper Type setting may be incorrect for the type of print
media you are using, or the print media may be too thick or have
a rough surface. (See Acceptable paper and other print media
on page 14 and Basic tab in the Software User’s Guide on the
CD-ROM.)
Printouts are too light. „ If this problem occurs when making copies, turn Toner Save
mode to Off in the machine menu settings. (See Toner Save
on page 24.)
„ Set Toner Save mode to Off in the Advanced tab in the printer
driver. (See Advanced tab in the Software User’s Guide on the
CD-ROM.)
Network difficulties
Difficulties Suggestions
Cannot print over a wired
Network. If you are having Network problems see the Network User's
Guide on the CD-ROM for more information.
Make sure your machine is powered on and is on-line and in the
Ready state. Print the Network Configuration list to see your
current Network settings. (See Network Configuration List
on page 26.) Reconnect the LAN cable to the hub to verify that
the cable and network connections are good. If possible, try
connecting the machine to a different port on your hub using a
different cable. If the connections are good, the lower LED of the
back panel of the machine will be green.