Brother HL-5350DN - Manual (Page 28)

28
Other Information
Laser Safety
This equipment is certified as a Class 1 laser product
as defined in IEC 60825-1+A2: 2001 under the U.S.
Department of Health and Human Services (DHHS)
Radiation Performance Standard according to the
Radiation Control for Health and Safety Act of 1968.
This means that the equipment does not produce
hazardous laser radiation.
Since radiation emitted inside the equipment is
completely confined within protective housings and
external covers, the laser beam cannot escape from
the machine during any phase of user operation.
FDA Regulations
U.S. Food and Drug Administration (FDA) has
implemented regulations for laser products
manufactured on and after August 2, 1976.
Compliance is mandatory for products marketed in
the United States. The following label on the back of
the equipment indicates compliance with the FDA
regulations and must be attached to laser products
marketed in the United States.
IEC 60825-1+A2:2001 Specification
This machine is a Class 1 laser product as defined in
IEC 60825-1+A2: 2001 specifications. The label
shown below is attached in countries where required.
This machine has a Class 3B Laser Diode which
emits invisible laser radiation in the Laser Unit. The
Laser Unit should not be opened under any
circumstances.
Use of controls or adjustments or performance of
procedures other than those specified in this manual
may result in hazardous invisible radiation exposure.
Internal laser radiation
MANUFACTURED:
Brother Technology (Shenzhen) Ltd.
NO6 Gold Garden Ind., Nanling Buji, Longgang,
Shenzhen, China
This product complies with FDA performance standards
for laser products except for deviations pursuant to Laser
Notice No.50, dated June 24, 2007.
WARNING
Maximum radiation power: 5 mW
Wave length: 770 - 810 nm
Laser class: Class 3B
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT