Brother PT-E550W - Manual (Page 28)

GETTING STARTED
28 Power Supply
Insert the rechargeable Li-ion battery into the battery
compartment.
Confirm that the hooks on the edge of the rear cover are inserted correctly, and then
reattach the cover.
 Removing the Rechargeable Li-ion Battery
Remove the battery cover and the rechargeable Li-ion battery, and then reattach the battery
cover.
 Charging the Rechargeable Li-ion Battery
The rechargeable Li-ion battery can be charged while it is inserted in the P-touch labeling
system. Perform the following procedure to charge the rechargeable Li-ion battery.
Make sure that the P-touch labeling system is turned off. If the P-touch labeling system
is turned on, press and hold the (Power) button to turn it off.
Make sure that the rechargeable Li-ion battery is installed in the P-touch labeling
system.
Use the AC adapter to connect the P-touch labeling system to
an AC power outlet.
The LED next to the adapter connector turns on during
charging, it goes off when the rechargeable Li-ion battery is
fully charged. The battery level indicator on the display will fill
three bars .
 Stopping Rechargeable Li-ion Battery Charging
To stop the rechargeable Li-ion battery from charging, disconnect the AC adapter.
2
3
If you cannot attach the rear cover, check to ensure the white lever is in the up position. If not, lift
the lever, and then attach the cover.
• Before using the rechargeable Li-ion battery, use the following procedure to charge it.
• Up to 6 hours may be needed to fully charge the rechargeable Li-ion battery.
1
2
3