Brother CE1100PRW - Manual (Page 33)

31
1
———————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
c
Lower the presser foot lever.
a Presser foot lever
d
Hold the needle with your left hand, and then
use a disc-shaped screwdriver to turn the
needle clamp screw counterclockwise to
remove the needle.
Note
● The needle can be removed by simply
loosening the needle clamp screw about
one turn. (If the needle clamp screw is
loosened too much, the needle clamp
(which holds the needle) may fall off.
Therefore, do not loosen the needle clamp
screw too much.)
a Disc-shaped screwdriver
b Needle clamp screw
• Do not apply strong force when loosening or
tightening the needle clamp screw,
otherwise certain parts of the sewing
machine may be damaged.
e
With the flat side of the needle toward the
rear of the machine, insert the needle until it
touches the needle stopper.
a Needle stopper
f
While holding the needle with your left hand,
use the disc-shaped screwdriver to tighten the
needle clamp screw by turning it clockwise.
Install the twin needle in the same way.
● Before replacing the needle, place fabric or
paper under the presser foot to prevent the
needle from falling into the hole in the needle
plate.
CAUTION
● Be sure to insert the needle until it touches
the needle stopper and securely tighten the
needle clamp screw with the disc-shaped
screwdriver, otherwise the needle may break
or damage may result.
CAUTION