Brother LX2500 - Manual (Page 30)

SEWING BUTTONHOLES AND BUTTONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
29
Sewing buttons
1
Measure the distance between the
buttonholes and set the pattern selection
dial to the Zigzag Stitch with the desired
width.
2
Turn off the machine.
3
Change the foot to the button sewing foot
“M”.
4
Place the darning plate on the needle
plate.
5
Turn on the machine.
6
Put a button between the foot and the
fabric and make sure that the needle enters
the holes without hitting the button. If it
hits, see step
1
.
7
At a slow speed, sew about 10 stitches.
CAUTION
8
Pull the upper thread at the end of the
stitching to the wrong side of the fabric,
and then tie it with the bobbin thread.
X Use scissors to cut the upper thread and
the bobbin thread at the beginning of the
stitching.
Stitch
Name
Pattern
Stitch
Length
[mm
(inch)]
Stitch
Width
[mm
(inch)]
Foot Other
Zigzag
Stitch
0.7
(1/32)
1.5
(1/16)
Button
Sewing
Foot
“M”
Darning
Plate
Zigzag
Stitch
1.5
(1/16)
3
(1/8)
Button
Sewing
Foot
“M”
Darning
Plate
Zigzag
Stitch
2
(1/16)
5
(3/16)
Button
Sewing
Foot
“M”
Darning
Plate
8
9
10
● Make sure the needle does not hit the
button during sewing. The needle may
break and you may be injured.