Brother Innov-is 4750D - Manual (Page 16)

15
m
Thread the machine with the thread for the
outline from step
o
, and then sew the
placement line for the appliqué position
(APPLIQUE POSITION).
a Pattern placement line
n
Lightly apply glue or spray adhesive, and
paste the appliqué piece so that it aligns with
the placement line.
o
With the machine threaded using the thread
for the outline from step
m
, sew the outline
(APPLIQUE).
a Outline of appliqué piece
p
After embroidering is finished, remove the
stabilizer material from the embroidery
frame.
q
Use scissors to cut the excess water-soluble
stabilizer from outside the appliqué outline.
r
Soak the appliqué piece in water to dissolve
the water-soluble stabilizer.
fi
s
Dry the appliqué piece, and then iron it if
necessary.
■ Using a Frame Pattern for the Outline
Using a frame pattern, the desired shape can be
added as the outline of the appliqué.
a
Perform the operations described in steps
a
through
e
of “Creating an Appliqué Piece”.
b
Select the desired frame shape and pattern,
and add it to the appliqué pattern.
Note
• Before pasting the appliqué piece down, make sure
the appliqué piece is positioned correctly within the
placement line.
Memo
• The outline is sewn using satin stitching.
• Some glue may get onto the presser foot, needle,
and needle plate at this time. Finish embroidering
the appliqué pattern, and then clean off the glue.
Note
• Do not apply a strong force when ironing, otherwise
the stitching may be damaged.