Brother Innov-is 4750D - Manual (Page 11)

10
d
Use to align the needle position with
the point of the thread mark.
a Needle position
e
After aligning the needle position for the
beginning of embroidering, remove the
thread mark.
f
Embroider the next pattern. To continue
embroidering a repeating pattern, repeat the
procedure starting with “Removing the
Border Embroidery Frame”.
Note
• After turning the handwheel to check the needle
position, press the "Needle Position" button to raise
the needle.
Note
• Remove the thread mark before starting to
embroider. Otherwise, the thread mark stitching may
be combined with the pattern stitching.
a
CAUTION
• If the sewing machine is turned off, then turned on
again with the border embroidery frame attached or
if you try to select a stitch from the Utility Stitch
screen or the Character/Decorative Stitch screen
while the border embroidery frame is attached, the
following message appears. If the border
embroidery frame is not fully removed from the
embroidery unit at this time, the border embroidery
frame may be hit by the presser foot when the
carriage of the embroidery unit is moved. When the
following message appears, fully remove the border
embroidery frame.