AMD GA-M61SME-S2 - Manual (Page 35)

- 35 - BIOS Setup
HDD S.M.A.R.T. Capability
This feature allows your hard disk to report read/write errors and to issue warnings when third-
party hardware monitor utility is installed.
Enabled Enable HDD S.M.A.R.T. capability.
Disabled Disable HDD S.M.A.R.T. capability. (Default value)
Away Mode
Disabled Disable this function. (Default value)
Enabled Enable Away Mode in Windows XP Media Center operating system.
(Away Mode: Enables the system to silently perform unattended tasks
while in a low-power mode that appears off. )
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install a PCI card and a PCI Express VGA card on the motherboard.
PCI Slot Set Init display first to PCI.
PEG Set Init display first to PCI Express VGA card. (Default value)
Onboard VGA Set Init display first to Onboard VGA.
Frame Buffer Size
32M Set frame buffer size to 32 M.
64M Set frame buffer size to 64 M. (Default value)
128M Set frame buffer size to 128 M.
256M Set frame buffer size to 256 M.
Disabled Disable this function.
Onboard GPU
This item allows the user to decide when to activate the onboard VGA function.
Enable If No Ext PEG
Activate the onboard VGA only when no PCI Express VGA card is installed. (Default value)
Always Enable
Always activate the onboard VGA, whether or not a PCI Express card is installed. If you wish
to set up a dual view configuration, set this item to Always Enable.