Brother HL-L8350CDW - Manual (Page 3)

3
DO NOT place the product near chemicals or in a place where chemicals could be spilled on it.
Should chemicals come into contact with the product, there may be a risk of fire or electric
shock. In particular, organic solvents or liquids such as benzene, paint thinner, polish remover,
or deodorizer may melt or dissolve the plastic cover and/or cables, resulting in a risk of fire or
electric shock. These or other chemicals may also cause the product to malfunction or become
discolored.
DO NOT put the product in a location that blocks or obstructs any slot or opening in the product.
These slots and openings are provided for ventilation. Blocking the product’s ventilation could
create a risk of overheating and/or fire.
Instead:
• Keep a gap of at least 4 in. (100 mm) between the ventilation hole and the wall.
• Place the product on a solid level surface.
• DO NOT place this product near or over a radiator or heater.
• DO NOT place this product in a “built-in” installation unless adequate ventilation is provided.
Keep a minimum gap around the machine as shown in the illustration.
(HL only)
(MFC and DCP only)
9.84 in.
(250 mm)
7.87 in. (200 mm)
4.00 in.
(100 mm)
4.00 in.
(100 mm)
9.84 in.
(250 mm)
4.00 in.
(100 mm)
15.70 in. (400 mm)
4.00 in.
(100 mm)