American Power Conversion 8000 VA - Manual (Page 9)

7
C ONNECT E QUIPMENT AND P OWER TO THE UPS
1. Connect equipment to the UPS.
2. Turn on all connected equipment. To use the UPS as a master ON/OFF switch, ensure all
connected equipment is switched ON. The equipment will not be powered until the UPS is
turned on.
3. Switch the utility circuit breaker on.
4. To power up the UPS press the button on the front panel.
• The UPS battery charges when it is connected to utility power.
• Allow at least 24 hours for the batteries to fully charge prior to connecting equipment to the
UPS.
5. Configure the Network Management card. Refer to the Network Management card user manual.