Acer 4530 - Manual (Page 39)

Chapter 2 29
On chip SATA Enable On chip SATA. Option: Enabled or Disabled
SATA Class ID Select the SATA Class ID. Option: IDE-ACHI Class,
HyperFlash Class, IDE-HyperFlash
Class, IDE Native Mode, Raid Class,
ACHI Class, or IDE Legacy Mode
SATA IDE
Combined mode Set SATA IDE Combined mode. Option: Disabled or Enabled
PATA Channel
Config Set the SATA channel as Primary or
Secondary channel. Option: SATA as primary or SATA
as secondary
ACHI ROM
POST delay Select SATA option ROM POST delay. Option: Disabled, 7, 6, 5, 4, 3, 2, or
1 second(s) delay
USB Host
Controller Enable or disable USB hardware. Option: Enabled or Disabled
Legacy USB
Support Enable support for Legacy Universal Serial
Bus. Option: Enabled or Disabled
Option ROM
Placement Determines which peripheral devices can
be booted.
NOTE: Changes to this setting can cause
the system to halt during boot.
Option: Disabled, Temporary, or
E000 Extend
Large Disk
Access Mode Set the Large Disk Access mode. Different
O/S require different drive geometry
representations. Select Other for UNIX,
Novell NetWare, or other O/S. Option: DOS or Other
Installed O/S Set the most commonly used O/S on the
system. Option: Other, Win2000, WinMe,
Win98, or Win95
Reset
Configuration
Data Clear Extended System Configuration Data
(ESCD) area. Option: No or Yes
Processor
Assisted
Virtualization Enable the hardware visualization support. Option: Enabled or Disabled.
Parameter Description Submenu Items