beautypg.com

Installation – Alpine cdm-9821 User Manual

Page 17

background image

15

-EN

Installation

1

Remove the Detachable Front Panel (refer to page
4). Slide mounting sleeve from main unit. (see
“Removal” on this page).
Slide the mounting sleeve into the dashboard.

NOTE
Please examine the installation. Make certain that no
external pressure is applied to either the top of the unit
or the removable nosepiece.

2

Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (

) already

attached to the vehicle’s chassis.

NOTE
For the screw marked

**

, use an appropriate screw for

the chosen mounting location.

Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDM-9823/CDM-9821.
Connect all other leads of the CDM-9823/CDM-9821
according to details described in the
CONNECTlONS section.

Mounting Sleeve
(Included)

CDM-9823/CDM-9821

No Pressure Here

No Pressure Here

Dashboard

Metal
Mounting
Strap

Chassis

Screw

Hex Nut (M5)

Bolt Stud

CDM-9823/CDM-9821

Ground Lead

∗∗

Lock Pin

Slide the CDM-9823/CDM-9821 into the dashboard.
When the unit is in place, make sure the locking pins
are fully seated in the down position. This can be
done by pressing firmly in on the unit while pushing
the locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install the
Detachable Front Panel.

Removal

1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push

the locking pins to the "up" position (see above
drawing). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock before
unlocking the second pin.

3 Pull the unit out, keeping it unlocked as you do

so.

3

Face Plate

Mounting Bracket

Ground Lead

CDM-9823/CDM-9821

Screws (M5

× 8)

(Included)

NOTE
Secure the ground lead of the unit to a clean metal spot
using a screw (

) already attached to the vehicle's

chassis.

5/12-15_CDM-9821(EN)

03.7.31, 11:27 AM

15

This manual is related to the following products: