Timeguard DCC2 - Manual (Page 7)

6
Fig 4ii
Cable knock
outs
Fixing holes
Fixing holes
iv Make the necessary wire terminations (see
fi g 2) and offer the external intercom up to
the back box. Tighten the fi xing screws as
indicated (fi g 4, iii).
v Slide the two end covers inwards as shown
until fully home (see fi g 4, iv).
End cover
End cover
Fig 4i
End plate
Screwdriver
notch
Fig 4iii Fig 4iv
Fig 5 – Rear access to nameplate
Screw holding PCB to
transparent housing
Catches on
transparent
housing
Transparent
housing
PCB
assembly
DCC1_DCC2_Instructs_1.4.indd 7 DCC1_DCC2_Instructs_1.4.indd 7 30/1/07 11:02:57 am 30/1/07 11:02:57 am