Timeguard LED100PIRWH - Manual (Page 7)

6
Walk Test and Adjustment
The purpose of Walk Test is used to test and adjust the detection coverage of
LED100PIR under auto mode.
• Adjust the Time knob to “T”, then conduct a walk test as described in test
procedure.
Test procedure:
• Adjust the Time knob to “T”, (Lux knob can be “Sun” or Moon”).
• Switch power On.
• Walk across the detection area, once the detector is triggered and the lamp will
turn On for 2 seconds.
Note walking direction when performing test.
Detector Head Adjustment
The detector head can be panned 90 deg.
to the left and 90 deg. to the right.
2 sec
Test mode
90º
90º