ProMariner ProNauticP - Manual (Page 7)

6 25
Typical Wiring Configurations
ProNautic 12
•
60 P
Power Factor Corrected & Global AC Input
DC Fuse DC Fuse DC Fuse
Main Grounding Bus
to Engine Negative
DC Charger Output
Case Ground
1 Size Smaller than the +
L
N
G
AC Input
12V Battery/Battery Bank
Typical 3 Bank12 Volt DC Common Ground Installation:
Important Safety Instructions
7. WARNING – RISK OF EXPLOSIVE GASES.
a) WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE
EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF
UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS
MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
b) To reduce risk of battery explosion, follow these instructions and those published by battery
manufacturer and manufacturer of any equipment you intend to use in vicinity of a battery(s).
Review cautionary markings on these products.
8. PERSONAL PRECAUTIONS
a) Someone should be within the range of your voice or close enough to come to your aid
when working near a Lead-acid battery.
b) Have plenty of soap and water nearby in case battery acid comes in contact with skin,
clothes or eyes.
c) Wear complete eye protection and clothing protection. Avoid touching eyes while
working near battery(s).
d) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid
enters eye, immediately flood eye with running cold water for at least 10 minutes and get
medical attention immediately.
e) NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
CAUTION - To reduce the risk of injury, charge only the battery types shown on
the ProNauticP user interface label i.e. Lead-acid type rechargeable batteries (Flooded,
Sealed Flooded, GEL (Gelled Electrolyte Lead-acid) or AGM (Absorbed Glass Mat)). Other
types of batteries may burst, causing personal injury. The ProNauticP is factory set for
Sealed Flooded (Lead-acid) batteries.
f) Incorrect assembly may result in electrical shock or fire.
g) Be extra cautious to reduce risk of dropping a metal tool onto a battery, it might spark or
short-circuit the battery or other electrical hardware that may cause a fire or explosion.
h) Remove all personal metal items such as rings, bracelets, necklaces, watches and jewelry
when working near a battery. A battery can produce a short circuit current high enough to
weld a ring or any other metal, causing serious burns.
i) Do not use the battery charger to charge dry cell batteries that are commonly used with
home appliances i.e. a cordless power drill battery. These batteries may burst and cause
injury to persons and damage to property.
j) NEVER charge a frozen battery.
9. PERSONAL SAFETY WHILE PREPARING TO CHARGE BATTERIES ON-BOARD
OR OFF-BOARD
a) If necessary to remove a battery(s) from a boat to charge, always remove the
negative (-) grounded terminal from battery first. Make sure all accessories in the boat
are off, so as not to cause an arc.
Battery Profiles Charger Conditions
Charger Mode Auto Maintain Conditioning Charging
AC Power
Auto Temp Control
Active PFC
Amps Volts
SYSTEM DC OUTPUT LEVELS
Variable Speed Cooling
Self Test
Fault
OK
Standby AUTO CONSERVATION MODES
100% 0%
Battery Health Program
Equalization
Charger Output
SETUP
ENTER
WARNING: HIGH VOLTAGE
ATTENTION : HAUTE TENSION WARNING: LOW VOLTAGE
ATTENTION : BASSE TENSION
P reset-1 P reset-2
Flooded
Sealed
AGM
GEL
LiFePO4-Lithium
Calcium/Custom
Reverse Polarity
DC Volts Low
DC Volts High
Charger High Temp
Check Fan
Digital ProMar Performance Charging
1 2 3
AVOID SERIOUS INJURY OR DEATH FROM ELECTRICAL SHOCK. BEFORE OPENING
TURN OFF AC SUPPLY POWER. DO NOT EXPOSE TO RAIN OR SPRAY.
CHOC ELECTRIQUES PEUVENT PROVOQUER LA MORT OU DE SERIEUSE BLESSURES.
AVANT D'OUVRIR LA BOITE, COUPER LE COURANT. NE PAS EXPOSER AUX INTEMPÉRIES. ELECTRICAL BURN AND SPARK HAZARD. BEFORE OPENING
DISCONNECT CHARGER CONNECTIONS AT BATTERIES.
(DANGER DE BRULURES ELECTRIQUE ET ETINCELLES). AVANT D'OUVRIR LA
BOITE DECONNECTER LES CONNECTIONS ENTRE CHARGEUR ET BATTERIE. DISPLAY WAKE UP: Press any key; SELF TEST: Hold all keys 5 seconds