beautypg.com

Prochem Legend GT User Manual

Page 39

background image

37

Maintenance

* Or as often as required
** Change solution pump crankcase oil after the first 50 hours
***Change engine crankcase oil and filter after the first 8 hours
****Perform drive belt, pulley and hub maintenance after the first 25 hours of operation, and then again at 100
hours
*****Tuthill Pneulube - Drain and replace oil after the first 100 hours, then drain and replace oil every 1000
hours, or once a year, whichever comes first.

Vacuum pump

250 hrs

Lubricate bearing on pulley end with grease

Vacuum Exhaust Heat Exchanger

500 hrs

Inspect cores and remove debris.

Solution Pump

500 hrs

Change oil**

Pulley Set Screws & Hub Cap Screws,

Solution Pump Clutch Shaft Bolts

500 hrs

Check for proper torque values. Re-torque, if
required****

Drive Pulley

500 hrs

Inspect, clean and check for pulley groove wear****

Drive Pulley

500 hrs

Check pulley alignment****

Drive Belts

500 hrs

Inspect and clean****

Drive Belts

500 hrs

Check belt tension****

Chemical Pump & Check Valves

500 hrs

Replace diaphragm, plastic disk and check valves.

Vacuum Lubrication Lines

500 hrs

Check for line obstructions. Replace tubing if cracked or
damaged

Engine

500 hrs

Replace in-line fuel filter on engine.

Engine 1000 hrs Replace spark plugs.

Chemical Pump & Check Valves 1000 hrs Replace diaphragm, plastic disk and check valves.

Check Valve (Solution Outlet) 1000 hrs Inspect, clean, and repair, if needed.

Waste Tank Shut-off Float Switch

Monthly

Check for debris hindering movement

Vacuum pump

Yearly

Drain and replace oil*****

Waste Tank Filters/Strainers

Yearly

Check for damage and blockage. Replace if needed.

Engine

Yearly

Replace air cleaner element

Engine

3 years

Replace ignition wires.

86313050 LEGEND GT