Ouellet OAM - Manual (Page 4)

4
TROUBLESHOOTING (CONTINUED)
SYMPTOM
POSSIBLE
CAUSE(S)
CORRECTIVE ACTION
Dryer will not run
Defective
circuit board
• First ensure that the breaker supplying the dryer is operational.
• If it is, disconnect the power and remove the dryer cover. Taking
suitable precautions to avoid shock hazard, reconnect the power and
check for voltage at the wire leads.
• If there is power and the dryer will not run, replace the circuit board.
Dryer cycles by
itself, runs all the
time, or is not
sensitive enough
Defective
circuit board
• Ensure that there is no obstruction on or in front of the infra‐red lens.
• Disconnect the power. Remove the dryer cover and the screws holding
the circuit board. Ensure that there are no obstructions between the
infra‐red “eyes” on the circuit board and the lens.
• If the problem persists, replace the circuit board.
Elements get hot
but the fan
motor does not
turn
Defective fan
or motor
• Disconnect the power. Remove the dryer cover and check for
obstructions in the fan housings.
• Damaged fans must be replaced.
• If there are no obstructions, replace the motor.
Fan motor runs
but the element
does not get hot
Loose or
damaged
wires or
defective
element
• Disconnect the power and remove the dryer cover. Check for loose or
damaged wires. Remove the access cover on the blower housing.
Check the element for signs of burning or breakage. Damaged element
must be replaced.
• If the element does not appear damaged, disconnect it at the circuit
board and check for continuity across the two element wires. An open
circuit indicates damage to the integral temperature limit control. If
this is the case, replace the element.
LIMITED WARRANTY TO OWNER
The warranties herein set forth are in lieu of all other warranties expressed or implied and shall not apply to any
accessory not part of the product. Ouellet Canada Inc. warrants its AirMulti unit to the owner against defects in
material and workmanship for a two (2) year period under normal use and services following date of purchase
when proof of such is provided to seller. The obligation of Ouellet Canada Inc., under the terms of this warranty,
shall be to supply a new part, or the repair of a defective part at the company’s option with no cost to owner for
the new or repaired part. Such parts are to be returned to the factory, or such other location as the company
may designate at the owner’s expense. This warranty does not obligate Ouellet Canada Inc. to bear the cost of
labor in replacing any assembly, unit or component part thereof, nor does the company assume any liability for
secondary charges, expenses for installing or removal, or any other consequential losses, freight or damages.
IN CASE OF PRODUCT FAILURE
It shall be the obligation of the owner or contractor to furnish to the company, within the designated warranty
period the following information:
1. Model Number and serial number of product involved.
2. Complete description of the problem encountered with product.