Ouellet OAM - Manual (Page 3)

3
7. Connect the supply wires to the terminal block where indicated. Connect the ground wire to the base plate
with the ground screw.
8. Replace the cover. Do not over‐tighten the screws.
Table 1
MAINTENANCE
Read complete instruction before proceeding. Proper maintenance should be performed on the units at least
every 6 months under normal use. More frequent cleaning is required in dirty environments or heavy conditions.
Lint and dust build up inside the dryer can result in damage to motor.
CLEANING INSTRUCTIONS
1. Disconnect the electrical supply.
2. Use the security hex driver to remove the two cover‐mounting screws.
3. Remove the cover.
4. Clean all dust and lint from the interior of the dryer using a soft brush and vacuum.
5. Replace the cover. Do not over tighten the screws.
6. Wipe the cover with a damp cloth. Never use abrasives to clean the cover.
TROUBLESHOOTING
! DANGER
• Always disconnect power before servicing.
! CAUTION
• Always confirm a good ground (earth) connection.
! WARNING
• Servicing should only be performed by persons trained and qualified to complete the servicing. Only
qualified professional service technicians or electricians should perform servicing involving electrical
circuits. Follow all local and national regulations when completing servicing.
RECOMMENDED MOUNTING HEIGHTS FROM FLOOR TO DRYER BOTTOM EDGE
in. cm.
Men’s washrooms 49 125
Women’s washrooms 47 119
Children’s washrooms, ages 4‐7 35 89
Children’s washrooms, ages 7‐10 39 99
Children’s washrooms, ages 10‐13 43 109
Children’s washrooms, ages 13‐17 47 119
Handicap Mounting Height 41 104